Sample System Configuration With A Custom Operation Panel And Environmental Equipment Connected - Sony SRP-X500P Operating Instructions Manual

Sample system configuration with a custom operation panel and
environmental equipment connected
In this configuration, the SRP-X500P can be controlled by a custom operation panel or an external system controller.
AN-820 UHF
Antenna or the
supplied antenna
Wireless
microphone
Document
camera
VIDEO OUT
Table-top
VIDEO OUT
microphone, etc.
VCR , DVD player,
etc.
Programmable
remote
commander
• The SRP-X500P and the connected devices can be controlled by commands sent by an external system controller to the
SRP-X500P. (System controller software is required.)
• The configuration above uses two WRU-806 UHF Synthesizer Tuner Units or two URX-M2 Tuner Units included in
the UWP-X7/X8.
• When an electret condenser microphone is connected to the MIC INPUT 3 or 4 connector, set the +48V ON/OFF switch
for the applicable connector to ON.
• When controlling the environment equipment such as screen, curtains, and lighting equipment through the REMOTE
PARALLEL connector, interface boxes are required.
For details on the use of a custom operation panel and interface boxes, see "REMOTE PARALLEL connector" (page 26).
Transmitter
LINE OUT
LINE OUT
MD recorder
RGB OUT
RGB OUT
PC PC
LINE OUT
PROJECTOR CONTROL RS-232C
AN-820 UHF
Antenna or the
supplied
Custom operation panel
antenna
(customer supplied)
Operation
terminal
External system controller
3 #
3 #
3 #
3
# 3 #
LINE
I/F
IN
BOX
I/F
BOX
LINE
I/F
OUT
BOX
System Configurations and Speaker Connections
Projector
INPUT
Front
speaker
(L)
Transmitter
Wireless
microphone
Front
speaker
(R)
To power
source
Screen
Rear
speaker (L)
Curtain
Rear
speaker (R)
Lighting
equipment
19