Table of Contents
Advertisement
10. SET DESTINATION
This menu is used to write the destination information in EEPROM.
Caution: After replacing MAIN P.C.B. or EEPROM (IC501 MAIN P.C.B.), be sure to change the destination
setting using this main menu. If the destination setting is not changed, "UNKNOWN DEST" is
displayed and proper operation is not available.
10-1 SELECT DESTINATION
Use the procedure described below to change the destination setting.
Every time the "MOVIE" key on the remote control is pressed, the destination setting item is displayed in
the order as shown below.
Have the desired destination setting displayed and select sub-menu "10-2 SET DESTINATION" by
pressing the " ▶ (right) " (Forward) key and " ◀ (left) " (Reverse) key on the remote control.
Caution: Selecting the destination setting item alone does not complete the procedure to change it.
Be sure to have Sub menu "10-2 SET DESTINATION" displayed.
No destination
1 0 - 1 D E S T ?
F destination
1 0 - 1 D E S T F
V destination
1 0 - 1 D E S T V
10-2 SET DESTINATION
This sub-menu is used to write the destination setting, which is selected by using "10-1 SELECT DESTINATION"
menu, to the EEPROM (IC501 MAIN P.C.B.).
U destination
1 0 - 1 D E S T U
"MOVIE" key
Forward
Sub-menu selection
Reverse
L destination
1 0 - 1 D E S T L
1 0 - 2 U
S E T !
DVR-700/NS-PSW700/NS-P700
C destination
1 0 - 1 D E S T C
G destination
1 0 - 1 D E S T G
A destination
1 0 - 1 D E S T A
53
Hide quick links:
Advertisement
Table of Contents
