Yamaha DVX-700 Service Manual page 17

● Check the New ID Number (Device key)
Connection
Connect the VIDEO OUT terminal of DVR-700 to the VIDEO IN terminal of the TV monitor with a video pin cable.
Operation Procedure
Perform following steps while watching the TV monitor screen and using the keys on the remote
control.
1. With this unit in the standby mode, press the keys on the remote control in the order as shown
below.
The self-diagnostic function is activated. (Fig. 3)
2. Press " (down) " key once to select main menu 22 DVD SETTING.
3. Press " (right) " key twice to select sub-menu 22-3 DVD ID CLR.
Self-diagnostic function starting display
1 - 1 V O L 1
4. Press "ENTER" key once. Wait about 15 seconds.
5. New ID number (device key) will appear on TV monitor screen as shown below.
Note: While the ID number is displayed, never operate any keys on the remote control.
6. To exit the self-diagnostic function, press "STANDBY/ON" key to turn off the power.
Fig. 3
Main menu 22 – DVD SETTING
D V D : - s e t t i n g -
Fig. 4
(Player's ID Number Setting)
ID Number ?
0 0 8 0 0 0 2 1 5
Compare
* * * * * * * * *
<CLEAR> Exit
Input ID Number !
Fig. 5
DVR-700/NS-PSW700/NS-P700
3
sub-menu 22-3 – DVD ID CLR
x x x : D V D I D C L R
New ID number (device key)
* The displayed "008000215" is an
example.
2
1
17