Makita DA4000LR Instruction Manual page 9

1
1. Hex wrench
1 2
4
1. Angle housing
2. Joint
3. Socket
4. Bolt
1 2
5
6
For higher speed operation
1. Angle housing
2. Joint
3. Socket
4. Spindle
5. Low
6. High
7. Two faces
Remove the chuck remaining bolt through the chuck opening
003068
by turning it counterclockwise with the hex wrench.
CAUTION:
• The drill chuck and the bolt are assembled each other.
Turn the bolt counterclockwise about 10 times so that
they can be removed together.
Loosen the bolts of the joint by the hex wrench and remove
003069
the angle housing, the joint and the socket.
3
To install the socket and the joint, fit the socket to the spindle
003070
so that the two faces are fitted perfectly. Then install the joint.
3
4
For higher speed operation, fit the angle housing marked
"LOW" to the joint. For lower speed operation, fit the angle
housing marked "HIGH" to the joint.
7
Rotate the angle housing to the desired position. Tighten the
003071
bolt with the hex wrench firmly. And retighten the another bolt
firmly again.
CAUTION:
• Be sure to tighten the two bolts firmly, or it may present a
risk of injury to persons.
9