Table of Contents
Advertisement
1. Chuck key
1
2
3
4
1. Stopper holder
2. Depth gauge
3. Side grip
4. Convex
5. Concave
1. Depth gauge
2. Side grip
Installing or removing drill bit
003056
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each of
the three holes and tighten clockwise. Be sure to tighten all
three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just
1
one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the original
position.
Depth gauge (optional accessory)
003060
The depth gauge is convenient for drilling holes of uniform
5
depth.
Loosen the side grip and remove it. Fit the convex on the
stopper holder to the concave on the tool barrel. Insert the
side grip into the stopper holder and screw the side grip.
Insert the depth gauge into the hole in the stopper holder.
003061
Adjust the depth gauge to the desired depth and tighten the
side grip firmly.
1
2
7
Advertisement
Table of Contents
