AEG S73400CTS1 User Manual page 44

44 www.aeg.com
Problem
The appliance does
not operate.
The light device
does not work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.
Possible cause
The plug is not connec-
ted to the mains socket
correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The light device is in
stand-by.
The unit is defective.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
7.1 Replacing the control unit
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
control unit. Contact your Service Cen-
ter.
Solution
Connect the plug to the
mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
control unit".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the food temperature
decrease to room temper-
ature before storage.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper-
ature.