Table of Contents
Advertisement
1
1. Stopper Pin
1
2
3
1. Blade Case
2. Hex bolt
3. Socket wrench
4. Blade guard
2
3
4
1. Shaft lock
2. Arrow
3. Blade case
4. Socket wrench
5. Hex bolt
Installing or removing saw blade
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before installing or
removing the blade.
•
Use only the Makita socket wrench provided to install or
remove the blade. Failure to do so may result in
overtightening or insufficient tightening of the hex bolt.
This could cause an injury.
Lock the handle in the raised position by pushing in the stop-
002193
per pin.
To remove the blade, use the socket wrench to loosen the
002215
hex bolt holding the center cover by turning it counterclock-
wise. Raise the blade guard and center cover.
4
Press the shaft lock to lock the spindle and use the socket
002216
wrench to loosen the hex bolt clockwise. Then remove the
1
hex bolt, outer flange and blade.
5
15
Hide quick links:
Advertisement
Table of Contents
