Drill Size; Screw Pitch; Wiring Connections; Connection Code - Rigid Industries dmx led effects Owner's Manual

4.2.1

Drill Size

The four outer mounting holes should be drilled with a #28 (9/64") size drill. The center
hole for the cable should be drilled with at least a Q (0.332") size drill for adequate cable
and grommet clearance.
4.2.2

Screw Pitch

If you require different length mounting screws or studs than those provided, the correct
thread pitch is #8-32. PLEASE USE CAUTION. Using screws that are of the wrong
length can cause them to bottom out and structurally damage the case.
4.3

Wiring Connections

Use the following instructions for connecting the Rigid Industries DMX LED
Effects control panel to your LED lights.
4.3.1 Connection Wire Color Code
4.3.2

Connectors

The connection between the LED light and the Rigid Industries DMX LED Effects control
panel should be kept free of moisture. If the panel is installed in a marine environment,
a marine grade dry connector must be used.
5

DMX NETWORK ARCHITECTURE AND TOPOLOGY

5.1 Setting up your DMX LED Effects
The Rigid Industries DMX LED Effects will act as a DMX master in your DMX
network. Use this section to understand how the Rigid Industries DMX LED
Effects should be used with your DMX capable LED lights. Note that only one
DMX master may connect to a single DMX universe, if more than one is
connected DMX data will be corrupted.
8
COLOR
Red
Positive (+) DC Input 10-36V
Black Negative (-) DC Input 10-36V
Yellow DMX Universe 1 Positive(+)
Green DMX Universe 1 Negative (-)
Orange DMX Universe 2 Positive (+)
Brown DMX Universe 2 Negative (-)
White No Connect
USE