Table of Contents
Advertisement
2
COLOR SELECTION
This section will cover the color selection process and various color modes the
Rigid Industries DMX LED Effects control panel can control. The buttons on the
Rigid Industries DMX LED Effects control panel use capacitive touch
technology and will not physically depress when pushed. The electrical
characteristics of your skin are enough for the panel to detect that a selection
has been made.
2.1
RGBW Color Selection
Solid colors can be selected using the buttons on the left side of the DMX
control panel.
Note: Only one solid color can be selected at a time. If color mixing is desired
use the color wheel. See section 3.2.
2.1.1
Red
A single press of the red button will turn all the red channels (DMX slot 1) to full power.
2.1.2
Green
A single press of the green button will turn all the green channels (DMX slot 2) to full
power.
2.1.3
Blue
A single press of the blue button will turn all the blue channels (DMX slot 3) to full
power.
2.1.4
White
A single press of the white button will turn all the white channels (DMX slot 4) to full
power. Pressing and holding the White button for 3 seconds will go to all channels. The
light output color is slightly pink shade of white. This is due to all the color dies on at
once. It provides the absolute most light out of an RGB unit, albeit in a slightly
odd color.
2.2
Color Mixing
Color mixing is possible by using the color wheel. The Cycle button also allows
color mixing as it cycles through the color spectrum. Cycle speed can be
increased or decreased by the center rotary control.
2.2.1
Color Wheel
The color wheel is a fast way to select a color mix shown on the color wheel. When
using any color with no other mode selected, just touch the color you would like.
Note that the center color wheel will also allow for dimming and changing the speed of
the CYCLE mode, so it is important to know that using the color wheel will take charge
of the output only when not in the DIM or CYCLE mode.
5
Advertisement
Table of Contents
