Fog Lamps; Taillamps, Turn Signal; Stoplamps, And Back-Up; Lamps - Buick 2015 Regal Owner's Manual

10-32 Vehicle Care
High/Low-Beam Headlamps
(Uplevel)
The high/low-beam headlamps on
the uplevel headlamp system are
High Intensity Discharge (HID) and
should be replaced at the dealer.
Front Turn Signal and
Sidemarker Lamps (Base and
Uplevel)
1. Remove the outside cap from
the uplevel headlamp assembly.
2. Remove the bulb socket from
the headlamp assembly.
3. Remove the bulb from the
socket.
4. Reverse steps 1 3 to install.

Fog Lamps

To replace the fog lamp bulb:
1. Locate the bulb assembly under
the front fascia.
2. Disconnect the electrical
connector from the bulb
assembly.
3. Remove the bulb by turning it
counterclockwise and pulling it
straight out of the assembly.
4. Install the new bulb by turning it
clockwise into the assembly.
5. Reconnect the electrical
connector to the bulb assembly.

Taillamps, Turn Signal,

Stoplamps, and Back-Up

Lamps

To replace any one of these bulbs:
1. Open the trunk. See Trunk
Release on page 1-6.
2. Remove the trunk trim panel
push pin.
I n f o r ma t i o n P r o v i d e d b y :
3. Pull the trunk trim panel back to
gain access to the taillamp
assembly.
4. Remove the three nuts that
secure the taillamp assembly.
5. Remove the taillamp assembly
and disconnect the wiring
harness connector.
6. Turn the bulb socket
counterclockwise to remove it.
7. Pull the bulb from the socket.
8. Install a new bulb.
9. Turn the bulb socket clockwise
to install it.
10. Reverse Steps 2 4 to reinstall
the taillamp assembly.