Without Eassist) - Buick 2015 Regal Owner's Manual

10-78 Vehicle Care
y
3. Press then scroll
until Jump Start displays.
4. Press to activate the jump
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and the
display will show WAIT TO
START.
6. When the jump start is complete,
the display will show ATTEMPT
START or JUMP START
DISABLED.
If the vehicle is started, the
on-board jump start function will be
automatically disabled. If the vehicle
cranks but does not start, the
procedure may be repeated again.
If the vehicle start is still
unsuccessful, the jump start can be
attempted using the following jump
starting procedure under Jump
Starting (with or without eAssist).
On-board jump starting may be
unavailable due to the 12-volt
battery charge level, the eAssist
z battery charge level, power
or
capability, or an issue with the
eAssist system. In these cases, the
display will not be available because
of the power issue, or the DIC will
display JUMP START DISABLED
SEE OWNERS MANUAL.
Jump Starting (with or

without eAssist)

For more information about the
vehicle battery, see Battery on
page 10-26.
If the battery has run down, try to
use another vehicle and some
jumper cables to start the vehicle.
Be sure to use the following steps to
do it safely.
Batteries can hurt you. They can
be dangerous because:
They contain acid that can
burn you.
Warning
(Continued)
I n f o r ma t i o n P r o v i d e d b y :
Warning (Continued)
They contain gas that can
explode or ignite.
They contain enough
electricity to burn you.
If you do not follow these steps
exactly, some or all of these
things can hurt you.
Caution
Ignoring these steps could result
in costly damage to the vehicle
that would not be covered by the
vehicle warranty. Trying to start
the vehicle by pushing or pulling it
will not work, and it could damage
the vehicle.
The vehicle has a battery cover
which must be removed to gain
access to the battery for jump
starting.