Door Gaskets; Rollers And Leveling - GE ZIS360NM Technical Service Manual

3. Remove T-27 Torx screws (4) and hinge from the
bottom of the door.

Door Gaskets

The fresh food and freezer doors have magnetic
gaskets that create a positive seal to the front of the
steel cabinet. The center mullion also has magnets to
assist in door sealing. Improper installation of the door
gasket will cause same-poled magnets to oppose one
another, preventing the door from closing tightly.
The magnetic door gaskets are secured to the doors
by a barbed edge that locks into a retainer channel.
The side of the gasket that is nearest the handle of the
door has a stripe on the inside of the barb (see photo).
Replacement
1. Starting at any corner, pull the old gasket out of the
retaining channel.
2. Soak the new gasket in warm water to make it
pliable.
3. Push the barbed edge of the gasket into the
retainer channel.

Rollers and Leveling

This model has 4-point leveling provided by adjustable
rollers on the rear and leveling legs on the front. It also
has 2 nonadjustable front rollers that are used only for
unit positioning.
To level the unit:
1. Turn the 7/16-in. hex nut, located above the front
rollers, to adjust the roller on the rear of the unit.
Turn clockwise to raise, counterclockwise to lower.
2. Turn the front legs with a 1-1/4 in. open end
wrench to adjust the front of the unit. Turn
clockwise to raise, counterclockwise to lower.
Base Channel Spacer
Hex Nut
Wheel
– 11 –
Hinge
Bushing
Hinge
5/16"
Bolt
Door Stop
GEA01268
Stripe
(Handle Side
of Door)
Leveling Leg