Connecting Cables To The Ethernet Power Supply - 3Com 3CNJPSE24 User Manual

Installing the Ethernet Power Supply

Connecting Cables to the Ethernet Power Supply

All ports on the front of the Ethernet Power Supply are
configured as data "route-through" ports for all data wires
(pins 1, 2, 3, and 6).
Be sure to use a standard Category 5 straight-through cable
including all 8 wires (4 pairs).
Data In Ports
Using a standard Category 5 straight-through cable, connect
the cable leading from the Ethernet switch or hub to the "Data"
port.
Data & Power Out Ports
Using a standard Category 5 straight-through cable, connect
the cable leading to the end device to the corresponding "Data
& Power" port.
NOTE: Be sure to connect correspondingly numbered "Data"
and "Data & Power" ports.
Ethernet Power Supply User s Guide 2-3