Table of Contents
Advertisement
Rinse Aid
This product makes dishes sparkle and helps them to dry
without spotting. The dispenser is located on the inside panel
of the door.
When the low rinse aid indicator on the control panel
(Fig.2-6) and the indicator on the dispenser (Fig.2-7) lights
you must add rinse aid.
Note: When 3-in-1 or similar combination detergent tablets
are used, the rinse-aid is no longer required.
Loading the Rinse Aid
To load the rinse aid:
1.
To open the dispenser, turn the cap in a counter-
clockwise direction and remove (Fig.2-8).
2.
Pour in the rinse aid, making sure not to overfill. The
rinse aid indicator will turn off when full.
Regulate the amount of rinse aid used for each cycle by
turning the dose adjuster (Fig.2-9), located beneath the cap,
with a screwdriver.
There are 6 different settings; the normal dosage setting is 3.
IMPORTANT: Proper dosage of rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjuster should be turned to a higher setting. If
the dishes have white streaks, turn the adjuster to a lower
setting.
6
Fig.2-6
Low rinse aid indicator
Fig.2-7
Fig.2-8
Fig.2-9
Advertisement
Table of Contents
