Table of Contents
Advertisement
5. Installation
This dishwasher is for use in GB and IE only. After sales service
applies to GB and IE only.
Positioning the Dishwasher
Do not install the dishwasher in a room where the
n
n
temperature is likely to fall below freezing (0 °C).
Do not grip the door when moving the dishwasher.
n
n
The dishwasher should be aligned to the front of the adjacent
cabinets, with allowance made for the door thickness. The
dishwasher has water supply and drain hoses that can be
positioned on either to the left or the right.
Before installing the dishwasher into a kitchen cabinet,
holes must not be drilled into the sides, or door, to avoid
compromising the performance and operation of the
dishwasher.
A plastic self-adhesive anti-condensation strip is supplied
with the dishwasher. Fix the strip to the underside of the
worktop, along the front edge (Fig.5-1).
Connect up the cold water supply, the drain hose and the
electrical connections (see below) then slide the dishwasher
into the cabinet opening.
Cold Water Connection
Connect the water supply hose (supplied loose) to the cold
water inlet at the rear. Connect the other end to a ¾" BSP tap
connector (Fig.5-2). Make sure that the washers are in place
and that it is fastened securely in place.
IMPORTANT: If the water pipes are new or have not been
used for an extended period of time, run the water for
a while to make sure that the water is clear and free of
impurities BEFORE connecting to the dishwasher. Failure
to carry out this precaution may lead to the water inlet
becoming blocked and causing damage the dishwasher.
The water prssure should be between 0.03 Mpa and 1Mpa.
Pressures above 1Mpa will require a pressure relief valve to
be fitted.
Drain Hose Connection
Connect the drain hose to the water outlet. Insert the hose
into a drainpipe with a minimum diameter of 40 mm, or let it
run into a sink, making sure to avoid bending or crimping. If
necessary, fit a siphon trap (U-bend) with a connecting piece.
The free end of the hose must be at a height of between
50 -110 cm and must not be immersed in water (Fig.5-3).
WARNING! The connecting piece for the siphon trap
n
n
(U-bend) must be solidly fastened to the wall to
prevent the drain hose from moving and allowing
water to spill outside the drain (Fig.5-4).
•
DocNo.800-0503 - Installation - RDW459 dishwasher
ArtNo.800-0126 - Fitting the sealing strip
¾" BSP tap connector
Water hose
Waste
hose
20
ArtNo.800-0101 - Cold water connection
Washer
50cm
Waste hose support
( xed to wall)
To waste
Fig.5-1
Fig.5-2
Fig.5-3
110cm
Fig.5-4
Advertisement
Table of Contents
