Appendix; Frequently Asked Questions - Pyle PIPCAM5 Instruction Manual

4. APPENDIX

4.1 Frequently Asked Questions

Note: For most problems you might encounter, please check Network connections first.
Check the working status revealed by the indicators on the network server, hub, exchange and network card. If
abnormal, check the network connections.
4.1.1 I have forgotten the administrator username and/or password.
To reset the administrator username and password, press and hold down the RESET BUTTON for 30p
seconds. Release the power button and the username and password will be reset back to the factory default
administrator username and password.
Default administrator username: admin
Default administrator password: admin
4.1.2 Subnet doesn't match, dbclick to change
If IP Camera Tool shows error information "Subnet doesn't match, dbclick to change!" Please choose Obtain
IP from DHCP server. (Figure 2.2).
If it still shows this error after obtaining IP from DHCP server, please check local area connection of your
computer, change subnet, gateway of the camera. Keep them in the same subnet as your computer. (Figure
2.3).
4.1.3 IP Address configuration
Check whether IP address of the IP camera server shares the same subnet as your computer: Click My
Computer >Control Panel> Network & Dial-up Connections > LAN > Attributes >Internet Protocols
(TCP/IP), and check IP Address and Subnet Mask. Make sure they are in the same subnet when configuring
the camera's IP address manually.
4.1.4 Can't access IP camera via the Internet
54