Pyle PIPCAM5 Instruction Manual page 37

1. Login to the router.
2. Choose "Firewall", select "Virtual Servers"
3. Input the port (don't use
NOTE: The port and IP address should be the same as the camera.
DLINK:
1. Login to the router.
2. Choose "Advanced", select "Virtual Servers"
3. Input the port, IP address, Protocol, then click save.
NOTE: The "public port" & "private port" should be the same as camera's port, choose the protocol to be
"both".
After all these 4 steps are done, you can use DDNS, check the DDNS status from the camera as below, and
get the link of DDNS for internet viewing.
80) and IP address, then click save.
Figure 7.6
Figure 7.7
37