Monitor Position Adjustment; Remote Control Unit Preparation - Panasonic CY-VHD9401U Operating Instructions Manual

E

Monitor Position Adjustment

N
G
L
I
S
Open the Display Unit
H
7
[PUSH OPEN]
Maximum
120x
1 Push the display release button [PUSH OPEN]
until the display is unlocked.
(Press the button with one hand while holding
the display with the other.)
2 Open the display unit by both hands until a
comfortable viewing angle is reached.
Close the Display Unit
Move the display unit by both hands until the
display release button is locked.
Note:
≥ Always use both hands to open or close the
display unit.
≥ Always check that the display release button is
locked after closing the display unit.
≥ If the display unit cannot be locked, be sure to
consult your dealer and remedy the situation.
48
CY-VHD9401U/L
Display Unit Lateral Angle
Adjustment
30x
30x
You can swivel it to the left and right, 30˚ each way.
Hold the display unit by the non-slip part in the
upper half of it and adjust its lateral angle.

Remote Control Unit Preparation

Battery Installation
1 Remove the battery holder.
With the remote control unit placed on a fl at
surface:
1 Stick your thumbnail into the groove, and
push the holder in the direction of the arrow,
and at the same time
2 Pull it out in the direction of the arrow using a
tough pointed object.
Tough pointed
Back side
object
2
1
2
Install the battery on the battery holder.
Set a new battery properly with its (+) side facing
up as shown in the fi gure.
Lithium battery
(supplied)
Battery holder
3 Insert the battery holder back into its original
position.
Battery Notes
≥ Battery type: Panasonic lithium battery
(CR2025/1F) (supplied)
≥ Battery life: Approximately 6 months under
normal use (at room temperature)
Caution:
≥ Improper use of the battery may cause
overheating, an explosion or ignition, resulting
in injury or a fi re. Battery leakage may damage
the product.
≥ Do not expose the remote control unit to direct
sunlight.
≥ Do not recharge, disassemble, deform or heat
the battery.
≥ Do not put the battery in fi re or water.
≥ Immediately replace used up battery.
≥ Obey local ordinances when disposing of the
battery.
Note:
≥ To ensure that the remote control unit is not
lost or misplaced, use the accessory magic tape
("Velcro") to secure it at a safe place.
Magic tape ("Velcro")
(supplied)
≥ Remove all oil, water, surfaces where the magic
tapes are to be attached.
CY-VHD9401U/L
E
N
G
L
I
S
H
8
49