Maintenance; Emptying The Tank; Installing & Cleaning Reusable Cloth Filter - Craftsman 125.04267621-3 evolv Operator's Manual

Maintenance

Emptying the Collection Tank
1
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum.
(Fig. 2)
3. Undo the latches and remove the power
head from the collection tank. (Fig. 3)
4. Clear all dirt or debris from the collection
tank and hose. (Fig. 4)
5. Clean or replace the filters. (Fig. 5)
See filter cleaning instructions on
page 11-12.
6. Check the hose, attachments, and
power cord to verify that they have not
been damaged.
Installing & Cleaning Reusable Cloth Filter
1
Installing Reusable Cloth Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Remove power head and place in the
upside down position.
3. Slide reusable cloth filter down over the
filter cage making sure the whole cage
is covered. (Fig. 2 & 3)
4. Replace and lock the power head on to
the collection tank.
2
2 3
3
NOTICE! The filter included is made of
high quality material designed to stop small
dust particles. The filter should be used for
dry pick-up only. A dry filter is necessary
to pick up dust. If the dust filter is wet, it
will clog quickly and be very difficult to
clean. Handle the filter carefully when
removing it for cleaning and replacing it.
Check the filters for tears or small holes, a
small hole can let dust pass through and
out of the cleaner. Do not use a filter with
holes or tears, replace it immediately.
4
Removing and Cleaning Cloth Filter
1. With the removed power head in the
upside down position.
2. Carefully remove the reusable cloth filter
from the filter cage. (Fig. 4) Clean the
filter by gently tapping or brushing dirt
off. Cleaning should not be done
indoors in living areas.
3. Use a mild soap and water solution to
wash reusable cloth filter and rinse with
clean water. (Fig. 5)
4. Allow the wet filter to air dry for 24 hours
before installing onto the filter cage.
10
4
5
5