Advertisement
Mounting your Camera
3
2
1
You've got three points of articulation. The most obvious is the screw-secured elbow
joint in the centre of the stand (1). This one is pretty obvious and straight forward –
loosen the screw, adjust to the position you want, and then tighten the screw again
to secure in place.
The second point of articulation (2) is the radial joint where the neck of the stand
attaches to the base. To adjust this joint, loosen the locking ring by rotating counter-
clockwise. Rotate the camera and stand to the position you want then tighten the
locking ring. By using articulation points 1 and 2, you can aim the camera in virtually
any direction.
Point 3, located where the camera attaches to the stand, and is held in place by one
locking screw. Like point 2, it is a radial joint, allowing you to rotate the camera so
that no matter how points 1 and 2 are configured, the camera can still face upright.
Simply loosen the screw, rotate the camera to the upright position (so that up in your
pictures is actually up) then tighten the screw to lock into place.
Of course, there will always be some outlying cases where the camera and stand
simply won't fit where you want to mount them. Maybe you have a hanging awning,
or a drain pipe in an inconvenient spot. In these cases, we suggest obtaining a
mounting bracket, which should be available from any good hardware store.
5
Advertisement
