Troubleshooting The Slideout - Jayco 2016 ALANTE User Manual

SECTION 5 – SLIDEOUT SYSTEMS
After the slideout is extended, verify that the corners of the black rubber seal are
set up correctly. The corners of this seal are cut at a 45° angle. The top of the seal
must overlap the side of the seal to avoid the possibility of water penetration.
Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and
motor.
Maintenance
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have
been disconnected.
Your slideout system has been designed to require very little maintenance. To
ensure a long life of your slideout system, read, understand and follow these
simple instructions. This system contains a pre-lubed bearing that is lubricated
when the room is moved in and out. Do not spray oil or grease on the rails while
the room is extended.
T
ROUBLESHOOTING
If the slideout does not move when the slideout switch is depressed, follow these
steps.

Check the auxiliary battery (customer supplied) for a full charge and good
wire connections.

Check the 12-volt fuse or circuit breaker.

Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.

If the slideout is extended, refer to the following section on overriding the
specific slideout system installed on your RV.

If the slideout is retracted, leave it in that position.

Contact your dealer or Jayco Customer Service for repair assistance.
If the slideout extends crooked or only one side moves, follow these steps.

Follow steps on overriding the specific slideout system installed on your RV.

You may need to push the side that is not sliding to get it to retract all the
way.

Contact your dealer or Jayco Customer Service for repair assistance.
5-2
WARNING
T S
HE LIDEOUT
JAYCO CLASS A MOTOR HOMES
Fig. 5.4 Exterior
slideout room corner