Table of Contents
Advertisement
11. When operating the tool, keep the cord
away from the cutting area and position it
so that it will not be caught on the work-
piece during the cutting operation. Oper-
ate with proper hand support, proper
workpiece support, and supply cord rout-
ing away from the work area.
WARNING: It is important to support the
workpiece properly and to hold the tool
firmly to prevent loss of control which
could cause personal injury.
12. NEVER use tool with wood cutting blades
or other sawblades. Such blades when
used on this tool frequently kick and
cause loss of control leading to personal
injury.
13. Check the wheel carefully for cracks or
damage
before
cracked or damaged wheel immediately.
14. Use only flanges specified for this tool.
15. Be careful not to damage the spindle,
flanges (especially the installing surface)
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
6
operation.
Replace
or bolt. Damage to these parts could
result in wheel breakage.
16. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
Wait until the wheel attains full speed
before cutting.
17. Stop operation immediately if you notice
anything abnormal.
18. Never attempt to cut with the tool held
upside down in a vise. This can lead to
serious accidents, because it is extremely
dangerous.
19. Do not stop the wheel by lateral pressure
on the disc.
20. Some material contains chemicals which
may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow mate-
rial supplier safety data.
21. The tool must be used only for dry cutting.
DO NOT use water.
Advertisement
Table of Contents
