Jeep 2015 Wrangler Owner's Manual page 450

448 STARTING AND OPERATING
Sway Bar Switch
Press the SWAY BAR switch to activate the system. Press
the switch again to deactivate the system. The "Sway Bar
Indicator Light" (located in the instrument cluster) will
illuminate when the bar is disconnected. The "Sway Bar
Indicator Light" will flash during activation transition, or
when activation conditions are not met. The stabilizer/
sway bar should remain in on-road mode during normal
driving conditions.
Do not disconnect the stabilizer bar and drive on
hard-surfaced roads or at speeds above 18 mph
(29 km/h); you may lose control of the vehicle, which
could result in serious injury. The front stabilizer bar
enhances vehicle stability and is necessary for main-
taining control of the vehicle. The system monitors
vehicle speed and will attempt to reconnect the
stabilizer bar at speeds over 18 mph (29 km/h). This is
indicated by a flashing or solid "Sway Bar Indicator
Light." Once vehicle speed is reduced below 14 mph
(22 km/h), the system will once again attempt to
return to off-road mode.
I n f o r ma t i o n P r o v i d e d b y :
WARNING!