Stihl HL 45 Instruction Manual page 19

Set choke to g and pull starter rope
N
five times. Set choke to e and
continue cranking.
If the engine is warm (choke set to e)
Continue cranking until the engine
N
runs.
As soon as the engine runs
Squeeze the throttle trigger to
N
disengage the tongue – the engine
will settle down to idle speed.
If the engine stops during warm-up or
acceleration
Repeat the starting procedure as
N
described under "If the engine is
cold".
WARNING
Make sure the carburetor is correctly
adjusted. The cutting blades must not
move when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
Move the stop switch to O.
N
Other Hints on Starting
If the engine does not start
Make sure all settings are correct
N
(choke shutter, throttle trigger in
starting throttle position, stop switch
to I).
Repeat the starting procedure.
N
HL 45
If the engine still does not start
7
Move the stop switch to O.
N
Remove the spark plug boot (7).
N
Unscrew and dry off the spark plug.
N
Open the throttle wide.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Refit the spark plug.
N
Connect the spark plug boot (press
N
it down firmly).
Move the stop switch to I.
N
Set choke lever to e – even if the
N
engine is cold.
Now start the engine.
N
If fuel tank has been run completely dry
and then refueled
6
Press the manual fuel pump
N
bulb (6) at least five times – even if
the bulb is filled with fuel.
Now start the engine.
N
English
17