Phase CS-6R/Micro Installation Instructions

Install instructions for CS micro series:
CS-6R/Micro, CS-8R/Micro and CS-6DVT/Micro
T E C H N O L O G Y
Thank you for purchasing Phase Technology Professional Series
speakers. Before installing, please read through this installation
manual thoroughly.
Micro-Flange Grille
CS-6DVT/Micro
Choose the appropriate mounting location for each speaker.
When deciding upon a location, consider the following:
• Make certain your speaker wires can be run to or are accessible from these
locations.
• Make certain the wall or ceiling material is sturdy enough to support the
weight and vibration of the speakers.
• It is recommended that our pre-construction rough-in bracket assemblies
be used whenever possible in new construction.*
*The RB-14 for the 6" models and AC-CS8R-PCB is for the 8" model rough-in brackets are available for installations in new construction.
8005 W. 110th St., Suite 208 | Overland Park, KS 66210 | (855)663.5600 | www.phasetech.com | www.mseaudio.com
Aimable Tweeter
Flange
Flange Clamp
Screw (4x)
Flange
Flange Clamp
Screw (4x)
CS-6R/Micro, CS-8R/Micro
• Make certain the area behind the speaker is free of obstacles such as wall
studs, electrical wiring, pipes, etc.
• Each speaker should be positioned properly, relative to the listening area
for good coverage.
• Audio performance and room-to-room isolation will be improved if there is
some fiberglass insulation placed loosely behind the speaker.
Micro-Flange Grille