Sony CDX-601 Service Manual page 6

JACK BOARD
Remove the jack board of
the arrow.
1 ground point screw
(PTT2.6 × 6)
MAIN BOARD, SLIDE VARIABLE RESISTOR (ELEVATOR HEIGHT SENSOR) (RV202)
2 Remove three solders of
the slide variable resistor
(RV202).
7 screw
6
2 jack board
1 main flexible board
5 screw (FP)
(PTT2 × 4)
8 slide variable resistor
(elevator height sensor)
(RV202)
(CNJ101)
5 two screws (FP)
6 main board
2 Remove two solders of
the elevator motor leads (M104).
2 Remove two solders of
the switch board leads.
3 screw (PTT2 × 4)
4 heat sink (T)