Asus Maximus VIII Hero User Manual page 95

DO NOT remove the thermal module. The thermal conditions should be monitored.
The following item appears only when you set the DRAM Switching Frequency to [Manual].
Fixed DRAM Switching Frequency (KHz) [300]
This item allows you to set a higher frequency for a quicker transient
response speed. Use the <+> or <-> to adjust the value. The values range
from 300 KHz to 500 KHz with an interval of 50 KHz.
Do not remove the thermal module when the manual mode is selected. The thermal
conditions should be monitored.
Boot Voltages
CPU Core/Cache Boot Voltage [Auto]
The voltage for CPU at initial boot.
Configuration options: [Auto] [0.600] - [1.700]
DMI Boot Voltage [Auto]
The voltage for DMI at initial boot.
Configuration options: [Auto] [0.300] - [1.900]
Core PLL Boot Voltage [Auto]
The voltage for Core PLL at initial boot.
Configuration options: [Auto] [0.70000] - [2.40000]
CPU System Agent Boot Voltage [Auto]
The voltage for CPU System Agent at initial boot.
Configuration options: [Auto] [0.7000] - [1.8000]
CPU VCCIO Boot Voltage [Auto]
The voltage for CPU VCCIO at initial boot.
Configuration options: [Auto] [0.7000] - [1.8000]
Internal CPU Power Management
The subitems in this menu allow you to set the CPU ratio and features.
Intel(R) SpeedStep(tm) [Enabled]
Allows the operating system to dynamically adjust the processor voltage and cores
frequency to decrease the average power consumption and decrease average heat
production. Configuration options: [Enabled] [Disabled]
Turbo Mode [Enabled]
Allows you to enable your processor cores to run faster than the base operating
frequency when it is below power, current and specification limit. Configuration options:
[Disabled] [Enabled]
ASUS MAXIMUS VIII HERO
3-19