Sony DCR-SR50E Service Manual page 10

1-3-3. Self-diagnosis Code Table
Self-diagnosis Code
Block
Function
C 0 4
C 1 3
C 1 3
C 3 2
E 2 0
E 3 1
E 4 0
E 4 0
E 6 1
E 6 1
E 6 1
E 6 2
E 6 2
E 9 4
E 9 4
Note 1: Refer to " 11-2. Record of Self-diagnosis Check" of "2-5. SERVICE MODE", ADJ 9-852-138-51).
DCR-SR50E/SR60/SR60E/SR70E/SR80/SR80E_L2
Detailed Symptom/State
Code
0 0 Non-standard battery is used.
0 0 Disk is faulty.
0 2 Disk access error
5 0 Codec IC dose not return any reply
0 0 EEPROM data are rewritten.
0 0 Drive fault
0 0 Codec IC fault
0 1 Audio Codec IC fault
Difficult to adjust focus
0 0
(Cannot initialize focus.)
Zoom operations fault
1 0
(Cannot initialize zoom lens.)
The abnormalities in initialization of
the focus lens and the abnormalities in
1 1
initialization of the zoom lens occurred
simultaneously.
Handshake correction function does not
0 0 work well. (With PITCH angular
velocity sensor output stopped.)
Handshake correction function does not
0 1 work well. (With YAW angular velocity
sensor output stopped.)
Fault of writing to or erasing the
0 0
flashmemory
0 1 Fault of writing to or erasing EEPROM
-
Use the InfoLITHIUM battery.
Remove the power source. Reconnect it again and operate your
camcorder again
Remove the power source. Reconnect it again and operate your
camcorder again
Remove the power source. Reconnect it again and operate your
camcorder again
Make EEPROM data correct value. (Note 1)
Inspect or replacement of the hard disk drive
Inspect or replacement of the codec IC (IC2301on the VC-463
board) peripheral circuits
Inspect or replacement of the Audio Codec IC (IC2301 on the
VC-463 board) peripheral circuits
Inspect the lens block focus MR sensor (pin 2, 4 of CN1501
on the VC-463 board) when focusing is performed when the
focus buttons of the touch panel are pressed in the focus manual
mode, and the focus motor drive circuit (IC1501 on the VC-463
board) when the focusing is not performed.
Inspect the lens block zoom reset sensor (pin w; of CN1501 on
the VC-463 board) when zooming is performed when the zoom
lever is operated, and the zoom motor drive circuit (IC1501 on
the VC-463 board) when zooming is not performed.
Check whether the flexible board of the lens is broken, and
check whether it is inserted imperfectly. If there is no problem in
the flexible board, inspect the focus/zoom motor drive circuit
(IC1501 on the VC-463 board).
Inspect PITCH angular velocity sensors (SE701 on the CD-652
board) peripheral circuits.
Inspect YAW angular velocity sensors (SE702 on the CD-652
board) peripheral circuits.
Inspect the flash memory (IC2401 on the VC-463 board). (Note 1)
Inspect the EEPROM (IC2303 on the VC-463 board). (Note 1)
1-3
ENGLISH JAPANESE
ENGLISH JAPANESE
Correction