Advertisement
Installation precautions for the wired remote controller
S Do not install in a location near heavy oil, vapor or sulfurated gas otherwise, this product will deform which will lead to a system
malfunction.
S Do not install the unit in a location near flammable gas leaks. Once flammable gases leak and are left near the wired controller, a fire may
occur. Do not operate with wet hands or allow water to enter the wired controller otherwise, an electric shock may occur.
S The wiring should conform to the wired controller current otherwise, electric leakage or heating may occur which may result in fire. The
correct cables shall be used in the wiring. No external force may be applied to the terminal otherwise, wire cuts and heating may occur and
result in a fire.
S This manual contains the installation method for the wired controller. Refer to the wiring diagram in this manual to connect the wired
controller to the indoor unit.
S The wired controller operates in a low voltage loop circuit. Do not connect the 208- 230V power directly to the thermostat. Do not wire
this type of wire in the same loop. The wiring clearance between the configured tubes should maintain a range of 12- 20 inches
(305- 508mm) or more.
S The wired controller shielded wire must be grounded well.
S The wired controller connective cable should not be longer than 66 feet (20 meters).
This manual provides a detailed description of the precautions that should be taken during operation.
To ensure correct service of the wired controller, read this manual carefully before using the unit.
After reading this manual thoroughly, keep it for future reference.
4.7in (120mm)
INSTALLATION ACCESSORY
INSTALLATION METHOD
.83in (21mm)
Fig. 1 - Wired remote controller structure size
2
.52in (13.1mm)
1.9inches (50mm)
Advertisement
