Table of Contents
Advertisement
5.
Select ADVANCED > Advanced Setup > Wireless AP.
6.
Select the Enable AP Mode check box.
7.
Scroll down and select an IP address setting:
•
Get dynamically from existing router. The other router on the network assigns an
IP address to this router while this router is in AP mode.
•
Enable fixed IP settings on this device (not recommended). Use this setting if you
want to manually assign a specific IP address to this router while it is in AP mode.
Using this option effectively requires advanced network experience.
Note:
To avoid interference with other routers or gateways in your network,
NETGEAR recommends that you use different wireless settings on
each router. You can also turn off the wireless radio on the other router
or gateway and use the R8000 only for wireless client access.
8.
Click the Apply button.
The IP address of the router changes, and you are disconnected.
9.
To reconnect, close and restart your browser and type http://www.routerlogin.net.
Nighthawk X6 AC3200 Tri-Band WiFi Router
Network Settings
131
Advertisement
Table of Contents
