Table of Contents
Advertisement
Remote Control
Power Turns the sound bar
"on" or puts it in standby mode.
Night Effect Instantly reduces
master volume and bass
impact, and increases voice
channel reproduction, for
low-volume listening.
Mute Mutes and unmutes the
sound coming from the sound
bar and subwoofer.
Source Selectors
Opt 1 (Optical source connection)
•
Aux 2 (Analog/AUX source
•
connection)
Bluetooth pairing (Instant pairing)
•
Master Volume Up and Down ( + / – ) Adjusts the master
volume of the system.
Center Volume Up and Down ( + / – ) VoiceAdjust adjusts
the volume of dialogue and imaging
BASS Volume Up and Down ( + / – ) Adjusts the volume
of the subwoofer.
Music Control Selectors
Play/Pause
•
Skip Back
•
Skip Forward
•
"SOURCE/LEARN" To initiate, press / hold Source button
for three seconds.
1.
www.polkaudio.com
DSP Mode Selectors:
Movie
•
Music
•
Sports
•
SmartBar IR Remote Learning
Set Up Your TV's IR Remote Control For SmartBar™ Learning
For your sound bar to respond to your TV's original remote control,
you MUST FIRST program the bar to respond to your television's
original IR (Infra-Red) remote. An RF (Radio Frequency) remote will
not work. Other remotes (cable, satellite) will work only after you
have programmed the bar to respond to the TV's IR remote.
Note: The first and third LEDs, followed by the second and
fourth LEDs will flash in pairs three times to indicate a
failed learn. The bar will exit learn mode after several
unsuccessful attempts to learn an IR command.
Carefully repeat steps 1-3 below.
1
2
Press the
Enter Learn mode by
volume up
pressing and holding
button.
the source button for
3 seconds.
Programming Instructions
Your sound bar is programmed to respond to the remote control
that is included with the product. However, we strongly recommend
programming the sound bar to also respond to your existing
remote control using the steps illustrated below. This will enable you
to operate all of your components using a single remote control.
While programming the sound bar, ignore anything that may be
displayed on the TV screen.
Teaching Example: To teach your bar the "Volume Up" command
of your remote control:
1. The Sound Bar is turned on and the LED is dim white, and you
have sound coming from the bar.
2. Press and hold the "SOURCE/LEARN" button for 3 seconds.
LEDs 1 - 4 on the bar will pulse in ascending order.
3. Press and release the "Volume Up" button on the MagniFi One.
4. Hold your TV's original remote 6 inches to one foot from the
front of the sound bar.
owner's manual
3
Press the
corresponding
function on the
remote repeatedly
as the four LEDs will
flash white and fade to
indicate a successful
learned command.
5
Hide quick links:
Advertisement
Table of Contents
