Amana AAC051FRB Service Manual page 23

Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and
discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures
require power to be connected. Ensure all ground wires are connected before certifying unit as repaired
and/or operational.
5. Unbraze compressor discharge tube
connection to condenser coil.
6. Unbraze compressor suction tube connection
to evaporator.
7. Remove nuts securing compressor to base
pan.
8. Lift compressor up and away from chassis.
Unbraze Compressor
Suction & Discharge
Connections
STUD PART
OF BASEPAN
Evaporator Removal
To remove Evaporator:
1. Remove Front Frame assembly (see Front
Frame assembly removal).
2. Remove Outer Case (see Outer Case
Removal).
©2003 Maytag Appliances Company
!
WARNING
NOTE: Before opening any refrigeration system,
capture refrigerant in system for safe
disposal.
To reduce risk of personal injury or property
damage, take necessary precautions against
high temperatures required for brazing.
3. Evacuate sealed system (see paragraph
Evacuation, in Troubleshooting Information
section).
4. Unbraze Evaporator Suction connection to
compressor.
5. Unbraze Evaporator connection to capillary tube.
6. Remove 4 screws holding Evaporator to housing.
7. Lift Evaporator out and away at top from chassis.
Evaporator
Coil
16022379 Rev. 0
!
CAUTION
Unbraze Here
23