Condenser Removal - Amana AAC051FRB Service Manual

Button down

Hide thumbs

Table of Contents

Disassembly Procedures

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and

discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures

require power to be connected. Ensure all ground wires are connected before certifying unit as repaired

and/or operational.

Fan Motor Assembly Removal

and Disassembly

To remove Fan Motor Assembly (including Fan

Motor, (indoor) Blower Wheel, and (outdoor) Fan

Blade):

1. Remove Front Frame Assembly (see Front

Frame Removal).

2. Remove Outer Case (see Outer Case Removal).

3. Remove 2 screws securing Condenser Assembly

to Chassis (screws located on each side of

Condenser).

4. Remove screws securing Condenser Shroud to

Condenser Coil

5. Carefully rotate Condenser Coil to the right to

expose Fan Blade.

6. Remove Condenser Fan Blade by squeezing

mounting clamp with a plyers.

6. Remove Fan Blade.

7. Remove Rotary Control Box (see Rotary Control

removal).

8. Remove screws holding blower cover on.

9. Remove 4 screws holding Evaporator shroud.

10. Lift up Evaporator Coil and carefully rotate to

expose Blower Wheel.

11. Remove Blower Wheel while squeezing clamp

and pulling forward.

12. Remove screws holding fan motor to mount.

13. Remove Fan Motor.

14. Reverse procedure to reinstall Fan Motor.

WARNING

Blower Wheel