Dusting And Spreading Mode - Stihl SR 430 Instruction Manual

English
Discharge rate (l/min) without pressure
pump
Spray tube angle
Knob setting - 30°
1 0.12 0.11
2 0.16 0.14
3 1.70 1.50
4 2.48 2.34
5 3.20 2.66
6 3.73 3.28
Discharge rate (l/min) without pressure
pump, with ULV nozzle
Spray tube angle
Knob setting - 30°
0.5 0.05 0.04
0.65 0.08 0.08
0.8 0.13 0.12
Checking flow rate
Place the unit on the ground.
N
Fill the container with water up to
N
10 liter mark.
Machines without pressure pump
Set the standard metering knob to 6.
N
Start the machine.
N
Hold the spray tube horizontally, run
N
the engine at full throttle, spray the
contents of the container down to
the 5 liter mark and note the time
taken.
The time required to spray 5 liters fluid
should be between 110 and
150 seconds.
26
In case of deviations:
Check the container, hose system,
N
metering knob and optional
pressure pump for contamination
0° + 30°
and clean if necessary.
0.07
Check blower air intake and clean if
N
0.11
necessary.
1.25
Check engine setting and correct if
N
1.90
necessary.
2.34
If there is no improvement, contact your
2.83
dealer for assistance.
0° + 30°
0.04
0.07
0.10

Dusting and Spreading Mode

SR 450 only.
Metering lever
A
1
B
1
The discharge rate is infinitely variable
with the metering lever (1).
Position A (metering lever vertical –
N
feed closed
Position B (metering level parallel to
N
blower tube) – feed open
Discharge rates
The discharge rate is dependent on the
density and grain size of the product
used.
Granulate 0 - 9 kg/min
Powder 0 - 3 kg/min
SR 430, SR 450