Heater Installation; Before Installation - NewAir G80 Owner's Manual

HEATER INSTALLATION

N
electrician to install new outlets or circuits.

BEFORE INSTALLATION:


Disconnect the main power supply connection.

Supply cables should be 10 AWG (5.3 mm
(8.4 mm

The heater must be connected to an individual circuit protected by a
30 Amp circuit breaker.

Supply cables must be equipped with a dual pole circuit breaker rating
of at least 240V/30A.
CAUTION: High temperature, risk of fire, keep electrical cords,
drapery, furnishings, and other combustibles at least 3 feet (0.9
m) from the front of the heater and away from the side and rear.
WARNING: To reduce the risk of fire, do not store or use gasoline
or other flammable vapors and liquids in the vicinity of the heater.
: To prevent personal injury always use a licensed
OTE
2
) aluminum wires suitable for at least 60°C (140°F).
http://www.NewAir.com
8
2
) copper wires or 8 AWG