Advertisement
ASSEMBLY & INSTALLATION
1. Open the packaging and remove the parts. Confirm the product and parts
are in good condition.
2. Attach the two base pieces to the bottom of the heater panel with the
provided screws.
3. Connect the cord to an appropriate outlet. If there is power coming to the
unit, the orange LED will be on, and the heater will be in standby mode.
4. Install the heater on your wall:
• To install it on the wall, remove the two base pieces if they are already
attached.
• Make sure there is room for 12 inches of space on the top and bottom of
the unit, and at least 8 inches of space on both sides.
• Drill three holes – (A), (B), (C or D) in Fig. 5 – into the wall to allow for
insertion of drywall anchors. The diameter of each hole should be
slightly less than the width of the anchors, about 0.2 inches. The
distance between the holes should meet the requirements shown in
Fig.5 (next page)
• Insert the wall anchors into the three holes.
11
Advertisement
