Snmp - D-Link DWR-118 User Manual

Section 4 - Configuration
SNMP (Simple Network Management Protocol) is a widely used network monitoring and control protocol that reports activity on each network
device to the administrator of the network. SNMP can be used to monitor traffic and statistics of the DWR-118. The DWR-118 supports SNMP v1
or v2c.
SNMP Local: Select whether the local SNMP administration should be Enabled
or Disabled.
SNMP Remote:
Select whether the remote SNMP administration should be
Enabled or Disabled.
Get Community:
Enter the password public in this field to allow read-only access
to network administration using SNMP. You can view the network,
but no configuration is possible with this setting.
Set Community:
Enter the password private in this field to enable read/write access
to the network using SNMP.
IP 1 ~ 4:
Enter up to 4 IP addresses to use as trap targets for your network.
SNMP Version:
Select the SNMP version of your system.
WAN Access IP
If you want to limit remote access SNMP access, enter the IP
Address: address of the remote computer you will use to access this device;
all other IP addresses will be denied remote SNMP access.
D-Link DWR-118 User Manual

SNMP

40