Gigabyte GA-Z170-HD3P User Manual page 14

S S
5) SATA EXPRESS (SATA Express Connectors)
Each SATA Express connector supports a single SATA Express device.
S S _ _
S
S S U
S _
6) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
a RAID array.
S S _ _
5 4
SATA3
1 0
7
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS
Setup," "Peripherals\SATA Configuration," for more information.
S _
B S_
B
7) M2A_32G (M.2 Socket 3 Connector)
S S _ _
The M.2 connectors support M.2 SATA SSDs and M.2 PCIe SSDs and support RAID configuration through the
Intel Chipset. Please note that an M.2 PCIe SSD cannot be used to create a RAID set either with an M.2 SATA
®
SSD or a SATA hard drive and can only be used to build a RAID set with UEFI. Refer to Chapter 3, "Configuring
a RAID Set," for instructions on configuring a RAID array.
80A 60A
S _
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Use a screw driver to unfasten the screw and nut from the motherboard. Locate the proper mounting hole for
the M.2 SSD to be installed and then screw the nut first.
Step 2:
Slide the M.2 SSD into the connector at an angle.
Step 3:
Press the M.2 SSD down and then secure it with the screw.
On the motherboard there are three length adjustment holes for the M.2 SSD. Select the proper hole
for the M.2 SSD to be installed and refasten the screw and nut.
S
B S S B S S
3 3
S _
S F S F
S _
B S S
3
B_ B_
S F
S _
B_
SATA3 3 2
1
42A
F
_ 0
- 14 -
_ F
1 2 3
B_
U U
S S
_ _
U
S
_
Chipset supports RAID 0,
®
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
1
5 RXN
6 RXP
7 GND
S
S
_ _ _ _ 3 3
_ _ 3