Table of Contents
Advertisement
www.massportal.com
1.
Introduction
1.1.
User manual
This user manual includes such chapters as: Introduction, General description, Usage and Printing of 3D
objects. Please study this manual carefully before connecting, starting and using your printer and use your device
according to these instructions. Save this manual for future reference and use whenever needed. Whenever you
need additional clarification or information regarding the use of your Mass Portal 3D printer, feel free to browse
our support website
sales@massportal.com.
1.2.
Warranty
For individual users warranty time is 1 to 2 years (depending on country, but not less than the minimum
required by the state's law), for juridical entities (companies) the warranty is 1 year from the date of purchase. The
warranty does not cover the [open-source] software. You need to carefully follow the instructions and
recommendations from the User's manual and you must be able to present a proof of purchase upon request to
be eligible for warranty service.
1.3.
Safety
To avoid burns and physical damage do not touch the printer's head, heating plate or moving parts unless
the printer has been completely turned off and the heating parts (extruder head, heating plate) has been cooled
enough (to room temperature or less). The printer, filament and cabling must be placed so that it cannot be
unintentionally touched or hooked by clothing. If you need to clean the heating bed or the extruder use a clean
paper wipe or kitchen towel.
Warning!
Printing surface is made from glass which can crack rather easily so be very careful with it. The
heating bed can be sprayed lightly with non-flammable consumer plastics or glass cleaner and then wiped off with
a clean wipe. The screws which hold the heating bed must not be overtightened because it may crack when it
heats up. Avoid impacts and putting heavy objects on the heating bed or other parts.
Warning!
When printing especially with ABS plastic it will lightly emit fumes and smell so the premises
where the printer is located must be well ventilated, but must avoid draught. If the plastic is being cooled too
rapidly it may warp. If the plastic is burned it will emit toxic fumes.
Warning!
The printer must not be left unattended with children. This printer is not really a toy (for
children) and therefore children must always be accompanied and supervised by an adult when using this
product. Do not leave the printed objects, other plastic parts and tools unattended in the reach of small children to
avoid harm and choking hazard. Be careful when tooling printed objects.
Warning!
Do not touch printer's moving or heated parts when the printer is turned on or hasn't cooled
enough.
I.e. please use common sense when working with the printer and always make sure that your actions are
well justified. In case of doubt or further questions please contact us by e-mail sales@massportal.com.
1.4.
Protection
The printer is intended to be used only indoors. The ambient temperature must be between 15°C/59F
and 30°C/86F (including). When working outside this temperature range the printed object may not print so well.
The Mass Portal 3D printer under no circumstances must be subjected to high levels of humidity, excess heat,
water, frost or other condition which may damage the electronics or mechanical parts.
To avoid clogging of extruder it must always reside at least 0.2mm above the printing surface. The
extruder is intended to be heated up to 250°C/482F. Prolonged exposure at or above the maximum temperature
may damage the printer's head.
http://massportal.com/en/support/
or contact us by sending an e-mail to:
3
Advertisement
Table of Contents
