Table of Contents
Advertisement
www.massportal.com
Change from Balanced to High performance and click Change plan settings. Click Change advanced power
settings in the Edit Plan Settings window.
2) Find the Hard disk entry, open the Turn off hard disk after sub-entry and change the setting to 0 and
press OK.
3.3.
Insertion and retraction of plastic filament
3
least 170°C to avoid motor or tensioner damage.
2) Plastic filament. We use plastic filament with 1.75 mm in diameter. Manual insertion and retraction is
done from the back of the printer in the dedicated hole.
3) Pipe binding. In case the tip of the filament has melted so wide that it is unable to remove it, please
detach the binding from the pipe and snip the melted filament tip using pliers. After that you will be able to remove
the filament. The pipe can be removed from the binding only when the base of the pipe is squeezed together and
then pulled outwards.
To insert the plastic filament follow steps
below.
1) Filament tensioner screw. Always
make sure that the tensioner is released
by turning the screw with your fingers
2
outwards
inserting or removing filament. After
inserting the filament adjust the tensioner
by turning the screw clockwise until it feels
tight, but do not over tighten it. It must
move
evenly
commands from Repetier-Host Manual
Control tab are run: Extrude or Retract.
Please run the above commands only
when the head has been warmed to at
10
(counter-clockwise)
before
when
the
following
Advertisement
Table of Contents
