Disc Playback 19 - Magnavox MDV 530 VR Owner's Manual

Digital video disc player & video cassette recorder
Hide thumbs Also See for MDV 530 VR:
Table of Contents

Advertisement

Before you begin, turn on the TV, Stereo, and other equipment
connected to the DVD/VCR. Make sure the TV and the Stereo (if
applicable) are set to the correct channel.
Details are on pages 7-15.
1
Press STANDBY-ON to turn on the DVD/VCR.
2
Press DVD so the red DVD light appears on the
front of the DVD/VCR.
3
Press OPEN/CLOSE
the front of the DVD/VCR) to open the Disc tray.
4
Place a Disc into the tray. If the DVD is recorded on
only one side, place the Disc in the tray with the label fac-
ing up and the shiny side facing down. Some DVDs are
recorded on both sides. Make sure the label of the side
you want to play is facing up.
5
Press PLAY B. The tray will close and play will begin at
the first Chapter or Track. If a DVD menu appears instead,
see page 48. With some Audio CDs, playback will not
begin unless you press PLAY B.
Or, press OPEN/CLOSE
DVD/VCR to close the tray.
With MP3 and JPEG files, playback will begin from Track 1.
6
Press STOP C to stop playback.
Remember, this DVD/VCR
will play only certain Discs.
See page six for details.
(to the right of the disc tray on
A
or press the tray toward the
A

Disc Playback 19

STANDBY-ON
TIMER SET
SETUP
AUDIO
SUBTITLE
ANGLE
REC
REPEAT
REPEAT
A-B
C-RESET
SKIP/
CLEAR
CH
2
TITLE
MODE
RETURN
DISPLAY
DVD
VCR
DISC
OK
MENU
6
STOP
REW
FF
PAUSE
3
Press OPEN/CLOSE A
on the DVD/VCR.
4
Insert a Disc.
Helpful Hints
• An "X" may appear at the top right
corner of the TV screen when you
try a feature. Either the feature is
not available on the Disc, or the
DVD/VCR cannot access the feature
at this time. This does not indicate a
problem with the DVD/VCR.
• If a Disc is dirty or scratched, the
picture may appear distorted or
playback may stop. Remove the
Disc and turn off the DVD/VCR.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the DVD/VCR again and
reinsert the Disc for playback.
• When the DVD or CD light appears
on the display panel, the Disc is
loaded and ready for playback.
• When you press OPEN/CLOSE A
or PLAY (DVD) on the front of the
DVD/VCR when the power is off,
the DVD/VCR will turn on in DVD
mode. Otherwise, the DVD/VCR will
turn on in the mode in which it was
turned off.
1
SKIP/
CH
5
PLAY

Advertisement

Table of Contents
loading

Table of Contents