Tv/Vtr (When Connecting An Optional Tv Tuner, Etc.); Error Display - Clarion NX501E Owner's Manual & Installation Manual

TV/VTR (When connecting an optional TV tuner, etc.)

Problem
The image is not
displayed.
The display is dark.
When the camera is
connected, the image is
disturbed.
There are red, green, and
blue points in display.

24. ERROR DISPLAY

If an error occurs, one of the following displays is displayed.
Take the measures described below to solve the problem.
DVD PLAYER
Display
Invalid Disc
Invalid Disc
Invalid Disc
PARENTAL VIOLATION
Disc Region incorrect
If an error display other than the ones described above appears, press the Reset button. If the problem persists,
turn off the power and consult your store of purchase.
* When the Reset button is pressed, frequencies of radio stations, titles, etc. stored in memory are cleared.
Downloaded from Caradio-Manual.com Manuals
56 NX501E/NZ501E
Cause
The parking brake is not
engaged.
The brightness control is too
low.
The operating condition is
not good.
The headlight of the vehicle
is lit
Improper NTSC/PAL setting
--------------------
Cause
A disc is caught inside the DVD deck and
is not ejected.
A disc cannot be played due to scratches,
etc.
A disc is loaded upside- down inside the
DVD deck and does not play.
Parental level error
Region code error
Measure
Check that the parking brake is engaged.
Adjust the brightness properly.
The temperature inside the vehicle may be 0 or
lower. Set to an appropriate temperature (25 or so)
and check it again.
The display is made dark at night to prevent the
glare (When the headlight of the vehicle is lit in the
daytime, the display gets dark).
Set the PAL/NTSC properly according to the
camera.
This is not a failure, but a phenomenon peculiar
to a liquid crystal panel (The liquid crystal panel is
produced according to technology with very high
precision. Note that, though there are effective
pixels of 99.99% or more, pixel missing or normally
lit pixels account for 0.01%).
Measure
This is a failure of DVD deck's
mechanism and consult your store
of purchase.
Replace with a non-scratched,
non-warped disc.
Eject the disc then reload it
properly.
Set the correct Parental level.
Eject the disc, and replace correct
region code disc.