The History Graphs; The Parameters - Cisco BWX 120 User Manual

The History Graphs

The History Graphs
The History graphs plot the change in signal strength and signal quality over time. The graphs cover the
last minute and are updated every second. Read the graphs from right to left. The right side of the graph
represents the most recent status of your Modem.

The Parameters

At the bottom of the Connection Status window are four parameters. These parameters are BTS ID,
Network ID, Active SW Version, and Standby SW Version.
The BTS ID indicates the BTS to which the Modem is currently synchronized. The Network ID indicates
the network in which the Modem is allowed to operate. Active SW Version and Standby SW Version
indicate the version number of the software currently loaded in the "active side" and "standby side" of
the Modem's flash memory. The two letters in parenthesis following the release number indicate the type
of software load. JD indicates Joint Detection. The other type of load, Enhanced Nulling (EN), is no
longer supported.
WiMAX Mode WiMAX Mode
BWX 120 PCMCIA Modem User Guide
15-5
Chapter 15 Troubleshooting Using BWX Modem Diagnostics Tool
OL-16321-03