Fcc Notice - Orchid Kelvin EZ User Manual

To meet FCC requirements, shielded cables are required to
"This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation."
This equipment generates and uses radio frequency energy and, if not installed and
used properly in strict accordance with the manufacturer's instructions, may cause
interference to radio or television reception.
This device has been tested and found to comply with the limits for a Class B
computing device in accordance with the specifications in Subpart J of Part 15 of FCC
Rules, which are designed to provide reasonable protection against such interfer-
ence in a residential installation. Only equipment (computer input/output devices,
terminals, printers, etc.) certified to comply with the Class B limits may be attached
to this product.
If this equipment causes interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
1. Reorient the receiving antenna.
2. Relocate the computer with respect to the receiver.
3. Move the computer away from the receiver.
4. Plug the computer into an outlet which resides on a different circuit breaker
than the receiver.
5. If necessary, consult your dealer, or an experienced radio or television techni-
cian for additional suggestions.
You may find the booklet How To Identify and Resolve Radio-TV Interference
Problems helpful. It was prepared by the Federal Communications Commission and
is available from the U.S. Government Printing Office, Washington, DC 20402. Refer
to stock number: 004-000-00345-4.
Orchid Technology is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. It is the responsibility of the user to
correct such interference.
Operation with non-certified equipment is likely to result in interference to radio
and TV reception. The user must use shielded interface cables in order to maintain
the product within FCC compliance.
* For Kelvin EZ-PCI the FCC is DDS7EF1193-93-PCI. For Kelvin 64-VLB the FCC is
DDS7EF1093-93-KVL. For Kelvin 64-PCI the FCC number is DDS7EF1193-93-PCI. For
Kelvin 64-ISA the FCC number is DDS7EF0294-94-ISA.

FCC NOTICE

FCC# DDS7EF1093-93-KVL *
Certified compliant with FCC Class B limits, part 15
connect the unit to a Class B certified device
Kelvin User's Manual
Kelvin EZ-VLB
FCC
43