Epson TM-L90 User Manual page 10

2. Insert the roll paper spacer so that the front edge goes through the notch; then push down
the spacer so that the hook on the spacer and the shaft align.
Front edge
3. Push the roll paper spacer until you feel it clicks onto the shaft. Check that the roll paper
spacer slides smoothly to the left and right.
4. Slide the roll paper spacer to the appropriate width. You can use the ruler printed inside the
printer, aligning the inside edge of the spacer with the desired measurement.
Hook
Shaft
10 TM-L90 User's Manual
Notch
Roll paper spacer
Inside edge
Ruler