Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7214000100R00...
CAUTION: Procedures and tech- niques which, if not carefully followed, will result in damage to the equip- ment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for purchasing an electric fireplace from Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register Serial Number Rating Label with Label Model Number Please carefully read and save these instructions.
IMPORTANT INSTRUCTIONS ⑭ Use this heater only as WARNING: Remote control described in this manual. Any contains small batteries. Keep other use not recommended by away from children. If swallowed, the manufacturer may cause fire, seek medical attention immedi- electric shock or injury to persons. ately.
Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register 467 mm 2. If you have any technical ques- [18.4 in.] tions or concerns regarding the operation of your electric fire-...
Fireplace Installation Site Selection to persons. WARNING: To reduce the risk Review and consider all of the of fire, do not store or use gaso- following conditions before instal- line or other flammable vapors or lation: liquids in the vicinity of the heater. •...
(Figure 2) Wiring Diagram RELAY BOARD SWITCH BOARD LED STRIPS LED STRIPS (RGB) - FLAME (RGB) - MEDIA BLOWER MOTOR ELEMENTS FLICKER MOTOR CUTOUT THERMAL THERMISTOR AC/DC ADAPTER DISPLAY / CONTROL BOARD FLAME LED STRIPS (AMBER) LED DRIVER BOARDS www.dimplex.com...
Fireplace Installation unit to the live wire from the ate wire to meet local and power supply. national electrical codes for rated power consumption. • Connect the N and H1 wires from the unit to the neutral • Connect the L1 wire from the wire from the power supply.
(predrill if required). tion is complete. 5. Secure the wall bracket to the 1. Determine the mounting wall using the supplied 1½ in. location of the unit so that the (3.8 cm) mounting screws and www.dimplex.com...
Fireplace Installation Flush Mounted Installation - washers into the wall and/or wall anchors. 2x8 Framing 6. Install the bottom support CAUTION: Two people will be bracket to the wall centered required for various steps of with the wall mounting bracket, this procedure.
Media tray of the firebox (Figure 9). 2. Carefully mount front glass assembly so that the front glass hooks hang on the front glass mounts on the fireplace (Figure 9). 3. Use the supplied four Phillips www.dimplex.com...
Operation Figure 11 Figure 12 Floating Display same functions that it was set WARNING: This electric fire- to when it was turned Off and box must be properly installed the intake temperature will before it is used. be indicated on the Floating The unit can be controlled by Display either the manual controls which...
Page 14
The heater will cycle on and off Color Themes to maintain the desired set tem- Different presets of ambient light- perature. The default temperature ing color combinations contained setting is 72°F (22°C). in the unit. → Adjusted by pressing the www.dimplex.com...
Page 15
Operation → Changed by repeatedly press- utes to 8 hours). ing the corresponding button → To set the timer press the timer on the remote or the unit. button on the remote, repeat- • Cycles through the different edly, until the desired time is preset ambient lighting settings displayed.
The partially reflective glass is ing described in this manual, cleaned in the factory during the an authorized service repre- assembly operation. During ship- sentative should perform any ment, installation, handling, etc., other servicing. the partially reflective glass may www.dimplex.com...
Products, other than fireplace surrounds product. (mantels) and trims, covered by this limited warranty have been tested and What Dimplex will do in the event of a inspected prior to shipment and, subject defect to the provisions of this warranty, Dimplex...
Page 18
Warranty not commercially practicable or cannot place of business and all labour costs. be timely made, Dimplex may, in lieu of Such costs shall be the purchaser’s re- repair or replacement, choose to refund sponsibility. the purchase price for such product or What Dimplex and its dealers and service part.
Need help?
Do you have a question about the BLF7451 and is the answer not in the manual?
Questions and answers