Sharp 61R-WP5H Service Manual page 28

61R-WP5H
55R-WP5H
No. AdjustingPoint
5 3D Y/C separation
level adjustment
(R7000: Y/C3D
Unit)
6 Main Y signal level
adjustment
(R/C, Service
mode V113)
7 Main-screen tint
adjustment
(R/C, Service
mode V112)
8 Main-screen color
adjustment
(R/C, Service
mode V114)
Adjusting Conditions
Signal: NTSC standard half
color bar signal
Adjusting point:
(R7000: Y/C 3D Unit)
Specification:
0.8 ±0.05 Vp-p
Signal: NTSC standard half
color bar signal
Adjusting point:
Remote Control
(Service mode V113)
Specification:
0.5 ±0.05 Vp-p
Signal: NTSC standard half
color bar signal
Adjusting point:
Remote Control
(Service mode V112)
Signal: NTSC standard half
color bar signal
Adjusting point:
Remote Control
(Service mode V114)
Specification:
Normal color level
TP1801
0.7 ±0.05Vp-p
Adjusting Procedure
1. Receive the NTSC standard half color bar signal.
2. Connect the oscilloscope probe between pin (8)
of P7001 and GND.
3. Adjust R7000 so that the waveform amplitude of
the luminance signal at pin (10) of JA connector
on VCJ unit should be 0.8±0.05 Vp-p.
Note: The amplitude must be measured from the
black level to the white peak.
0.8Vp-p
1. Connect the oscilloscope probe between TP1801
and GND.
2. In the twin-picture mode, receive the NTSC stand-
ard half color bar signal for the left-side screen (Main
Screen).
3. Using the VOLUME UP/DOWN keys in the Service
mode V113, adjust the waveform amplitude of the
main luminance signal at TP1801 to 0.5±0.05 Vp-p.
Note: The amplitude must be measured from the
black level to the white peak.
1. Set the AV mode to "STD-1".
2. In the twin-picture mode, receive the good local
channel for the left-side screen (Main screen).
3. Enter the Service mode V112. Using the VOLUME
UP/DOWN keys, visually adjust the tint to the best.
1. Take the same steps 1. and 2. for the tint adjust-
ment.
2. Enter the Service mode V114. Using the VOLUME
UP/DOWN keys, visually adjust the color to the
best.
3. Switch the channels. Make sure the color is opti-
mum on other channels.
28