Control Of The Tv - Sharp Aquos LC-80UH30U Operation Manual

<< Using a PC

Control of the TV

The TV can be controlled from a PC, control panels and other devices
using the RS-232C.
Use a cross-type RS-232C cable (commercially available) for the
connections.
NOTE
This operation system should be used by a person who is
accustomed to using computers.
AQUOS Remote Control
Set this function when operating the TV from equipment connected by
LAN or wireless LAN. To perform the operation, refer to "TV Setup" >
"General".
Remote Control App
When "Remote Control App" is selected, "Change" will be highlighted.
Press (ENTER).
Detailed Settings
Make the detailed settings (Login ID, Password).
Follow the on-screen instructions to configure the settings.
Device name
Set the name of the TV displayed on other network devices.
Configure the settings from "HOME" > "Settings" > "Device" > "About" >
"Device name".
Communication Conditions for RS-232C
Set the RS-232C communication settings on the PC to match the TV's
communication conditions.
The TV's communication settings are as follows:
Baud rate:
Data length:
Parity bit:
Stop bit:
Flow control:
Communication procedure
Send the control commands from the PC via the RS-232C.
The TV operates according to the received command and sends a
response message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before sending the next
command.
ENG 8­2
ENGLISH | FRANÇAIS | ESPAÑOL
9,600 bps
8 bits
None
1 bit
None
>>