Installing The Bar Speaker On A Wall - Sony HT-CT80 Operating Instructions Manual

Installing the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
More than 30 mm (1
Hole on the rear of the Bar Speaker
3
4 mm ( / in)
16
3
/ in)
16
4.6 mm
3
( / in)
16
9 mm
9
( / in)
25
2
Fasten the screws to 2 studs in the
wall.
The screws should protrude by
9 mm to 10 mm (approx.
9 mm to
10 mm
(approx.
3
/ in)
8
3
Hang the Bar Speaker on the
screws.
Align the holes at the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
3
/ in).
8
447 mm
3
(17 / in)
5
11
GB