Replacing The Battery - SeaDoo Seascooter RS1 User Manual

REPLACING THE BATTERY

To remove the Inner Nose Cone and replace the Battery Pod, user MUST follow these instructions to avoid any injury.
1. ALWAYS ensure that the Master Switch is in OFF position. (see Fig. 12)
2. ALWAYS ensure that the Seascooter is out of the water, dry and placed in a dry area.
3. Pull the three Latches down and remove the outer nose cone. (see Fig. 13 & 14)
4. Release the Vent plug on top of the Nose Cone. (see Fig. 15)
5. Tie up the rubber rings together and pull them through the slots of the inner nose cone and attach both ends around the handle and bottom latch
hinge as shown in Fig. 16.
6. Remove the pump nozzle from the pump, and screw it to the vent chamber.
7. Connect the pump to the Pump nozzle and pump air in until the Nose Cone pops off (see Fig. 17).
IMPORTANT: ALWAYS attach the Rubber Ring before using the pump. The Nose Cone can pop off and cause injury if the Rubber Ring is not
attached and tightly secured.)
8. Remove the Rubber Ring and the Inner Nose Cone. (see Fig. 18)
9. Take out the Battery Pod from the unit. (see Fig. 19)
10. Replace with a new suitable battery pod.
IMPORTANT: RS1 battery pod is suitable for use in the RS1, RS2 and RS3 Seascooter. RS2 battery pod is only suitable for use in the RS2 & RS3
Seascooter. RS3 Battery pod is only suitable for use in RS3 Seascooter).
12 13 14 15 16
8